Help Can softbody be used on cloth?

[astest]

If they don't collide at all, check that:

1.- Both the cloth and the softbody belong to the same solver. Actors in different solvers won't interact with each other in any way, since they're part of different simulations. See:
http://obi.virtualmethodstudio.com/manua...olver.html


Just realized that in your video you seem to have 2 separate solvers, one for the cloth and another one for the softbodies. This will ensure they are simulated separately and don't know about each other's existence.

2.- Particle collisions are globally enabled in the ObiSolver component, under the "constraints" foldout.

3.- Collision filters are properly set up for both the cloth and softbody (that is, they're not set to ignore each other's category). See:
http://obi.virtualmethodstudio.com/manua...sions.html

4.- The mass of the cloth and the softbody particles are comparable, you can check this in the blueprint editor. If the softbody is much heavier than the cloth, it will push it out of the way and end up passing trough it.

kind regards,

Thank you very much!!! It's working fine.