Obi Official Forum › Obi Users Category › Obi Fluid v
Help  ObiParticleRenderer works fine but ObiFluidRenderer does not work in 'FluidMixing'

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Help  ObiParticleRenderer works fine but ObiFluidRenderer does not work in 'FluidMixing'
psk_1603 Offline
General User
Posts: 3
Threads: 2
Joined: Jan 2019
Reputation: 0
#1
31-01-2019, 12:13 PM
안녕 ~!
샘플 장면 'FluidMixing'을 테스트하고 있습니다.
나는 ObiFluidRenderer를 시도했다.
기본 카메라의 ObiFluidRenderer 구성 요소를 활성화했지만 작동하지 않습니다. 어떻게해야합니까?
Find
Reply
josemendez Offline
Forum Admin
*******
Posts: 6,348
Threads: 24
Joined: Jun 2017
Reputation: 400
Obi Owner:
  • Rope
  • Cloth
  • Fluid
#2
31-01-2019, 12:25 PM (This post was last modified: 31-01-2019, 12:39 PM by josemendez.)
(31-01-2019, 12:13 PM)psk_1603 Wrote: 안녕 ~!
샘플 장면 'FluidMixing'을 테스트하고 있습니다.
나는 ObiFluidRenderer를 시도했다.
기본 카메라의 ObiFluidRenderer 구성 요소를 활성화했지만 작동하지 않습니다. 어떻게해야합니까?

Hi,

This is a shot in the dark, but make sure that the camera's near plane is a bit further way from the default. Set the near plane to 1 and the far plane to 100, see if it improves.

Edit: Also make sure that in the ParticleRenderer, radius is set to at least 2. For lower values, the default density threshold of the FluidRenderer will cull out all particles.
Website Find
Reply
psk_1603 Offline
General User
Posts: 3
Threads: 2
Joined: Jan 2019
Reputation: 0
#3
31-01-2019, 02:01 PM
(31-01-2019, 12:25 PM)josemendez Wrote: Hi,

This is a shot in the dark, but make sure that the camera's near plane is a bit further way from the default. Set the near plane to 1 and the far plane to 100, see if it improves.

Edit: Also make sure that in the ParticleRenderer, radius is set to at least 2. For lower values, the default density threshold of the FluidRenderer will cull out all particles.

Set radius to 2 or higher so it works. Thank you. Guiño
Find
Reply