Softbody 2d intercollision

[lethemre]

Im using obi in 2d mode and have 2 softbody in my scene. Everything is okey but intercollisions not working. They did not collide each other.

[josemendez]

Im using obi in 2d mode and have 2 softbody in my scene. Everything is okey but intercollisions not working. They did not collide each other.

Hi there,

I can't help much since you gave no info at all on about how you've setup the scene, all you mention is that this is 2D. Some general advice:

- Make sure both softbodies are included in the same solver. Actors in different solvers won't interact with each other.
- Make sure the solver has "particle collision constraints" enabled (under the Constraints foldout). If these are globally disabled for the solver, particles won't collide with each other.
- Make sure collision filters are setup properly.

kind regards,

[lethemre]

Hi there,

I can't help much since you gave no info at all on about how you've setup the scene, all you mention is that this is 2D. Some general advice:

- Make sure both softbodies are included in the same solver. Actors in different solvers won't interact with each other.
- Make sure the solver has "particle collision constraints" enabled (under the Constraints foldout). If these are globally disabled for the solver, particles won't collide with each other.
- Make sure collision filters are setup properly.

kind regards,

Thank you for quick reply it was particle collision constraint