Help Multiple cloth interleaving problems

[litefeel]

Hi. I'm a newbie for Obi Cloth.
The Obi Cloth is cool and powerful.
Now. I have a problem.
My model has multiple pieces of cloth, When I add a wind, they will be intersect. Like below.
How can we separate them.

[josemendez]

Hi there,

Simply enable self-collisions. in your ObiCloth component. Make sure that particle collision constraints are globally enabled in the solver too. See:
http://obi.virtualmethodstudio.com/manua...sions.html

You can then play a bit with particle radius to make self collisions more robust, in case you need.

[litefeel]

Hi there,

Simply enable self-collisions. in your ObiCloth component. Make sure that particle collision constraints are globally enabled in the solver too. See:
http://obi.virtualmethodstudio.com/manua...sions.html

You can then play a bit with particle radius to make self collisions more robust, in case you need.

Thanks for your reply.

I did the following:
1. Enabled `Particle Collision` on Obi Solver
2. Enabled `Self collisions` on Obi SkinnedCloth
3. Increase the radius of the particles
4. Brush the diffent phase of the cloth

Now.  they will still intersect.
How to make them not penetrate?
Thanks.

[josemendez]

Hi,

Based on the video, there's quite large gaps in-between particles, the particles at the corners are very small, and you're only using 1 iteration in parallel mode (which converges much more slowly than sequential, see: http://obi.virtualmethodstudio.com/manua...gence.html).

Make your particles larger (they should at least overlap a bit), and use 3 particle collision iterations in sequential mode.