10-08-2020, 03:29 PM
(This post was last modified: 10-08-2020, 03:30 PM by josemendez.)
(10-08-2020, 03:18 PM)voodoo-bird Wrote: Thank you for your quick reply. However I have a new question. I have attached one end of the rope to a physics driven helicopter. Flying that shows the rope looking normal attached. So I attached to a cube with a rigid body and only .1 mass, but the rope just gets longer instead of lifting up the cube or stopping the helicopter from getting higher. This is with default configuration for the rope.
What am I missing? I don't want the rope to stretch at all.
Make sure you're using a dynamic attachment, not a static one. As explained in the manual static attachments are only one-way, not two-way. See:
http://obi.virtualmethodstudio.com/tutor...ments.html