Help The easiest way to create complex rope?

[PlayLikePro]

Hi there,

Mmmm...if you intend to simulate this using particle-based ropes, you're in for a lot of headaches.

The rope shown in the image seems to be under a lot of tension, lots of self-collisions and collisions against small holes, all of which require extreme precision to be solved. Collisions and self-collisions in Obi are resolved at the particle level, which is great for fast realtime stuff, but fails when there's a lot of collisions and/or the rope tension is high (as gaps might open between particles, and other particles can slip trough).

Is it really necessary to perform a fully realtime dynamic simulation of this? It looks like a static sculpture, without much movement going on. You'd be wasting away CPU cycles/processing power unless there's a fair deal of realtime dynamics involved.

If you're worried about the physical plausibility of the resulting web of interwoven threads, then perform an offline simulation, as you can spare as much simulation time as you need to get the required accuracy. Once it is finished simply import the result (splines, meshes, whatever you choose) into Unity.

Hi josemendez,
Thank you so much for the quick response! 
This image shows how our idea operates:
[attachment=199]
The ropes first go through each holes on the frames, which then separates to create a 3-D structure.
The length of the rope is not fixed because we leave one end still on spool so it can length.
It is a idea of transformation from 2-D pattern to 3-D structure.
The rope's self-collisions are dependent on whether one thread is on top of the other before pulled apart. 


And the apple was a playful thing, not a part of the project. 
What really matters to us is the unpredictable nature of transformation from 2-D to 3-D.
we aim to study the cause-and-effect relation.

Could you say more about using spline to make Obi Rope?
Which documentation or link should I look at?
I currently only know how to use Obi Rope(fully setup).

If "one continuous thread simulation" won't work: 
Because the thread is continuous, theoretically it has the same tension distribution along its entire length if disregard frictions. 
Other than simulating it as one thread, could we make each thread connecting two holes an individual thread, but with constant tension? 
I imagine they can automatically lengthen when reach a predefined tension when pulled apart.


Thank you so much again for your response!
Best regards,
Po