07-12-2025, 12:40 PM
(This post was last modified: 07-12-2025, 12:41 PM by josemendez.)
(07-12-2025, 05:04 AM)chenji Wrote: Hello any insights on this? Any suggestions are welcome!
Hi!
My approach to this would be to simply modify the rod meshes procedurally. This allows you to have a single mesh for all your rods and simply select the length you wish the rod to have.
If your fishing rod meshes are straightened along an axis (Y for instamce), this is very simple: just pick all the vertices above a specific Y coordinate (leaving out those below, belonging to the handle) and move them further/closer apart along the axis before feeding the mesh to the rod renderer.
kind regards,