30-11-2025, 01:07 AM
Hi,
I have a Obi rod with uses Obi rod mesh renderer. The rod contains two parts: handle and body. There are lots of type of this rod and the only difference is the length of the rod body, the handle mesh are same in these different types. As Obi rod mesh renderer only takes one mesh and will streching all the mesh for the specified rod length, now I have to make lots of meshes to get what I need. Is there any trick to only use one mesh (or two split mesh for handle and body), let Obi rod strech only the body part of the rod mesh, and let the whole rod's physics behavior controlled by Obi rod?
I have a Obi rod with uses Obi rod mesh renderer. The rod contains two parts: handle and body. There are lots of type of this rod and the only difference is the length of the rod body, the handle mesh are same in these different types. As Obi rod mesh renderer only takes one mesh and will streching all the mesh for the specified rod length, now I have to make lots of meshes to get what I need. Is there any trick to only use one mesh (or two split mesh for handle and body), let Obi rod strech only the body part of the rod mesh, and let the whole rod's physics behavior controlled by Obi rod?