Yesterday, 04:43 PM
(This post was last modified: Yesterday, 04:51 PM by quent_1982.)
(Yesterday, 04:34 PM)josemendez Wrote: Should work fine, I've tested moving an attached object with a configurable joint using these settings but couldn't reproduce this issue. Would it be possible for you to send a project that reproduces this issue to support(at)virtualmethodstudio.com so that I can take a closer look at your setup?
kind regards,
Unfortunately, I`m unable to send the project due to my obligations at work.
Is there other way to provide you some info that can help you understand the problem closer?