Particle Dragger Inaccurate

[josemendez]

I'm using the particle dragger on a softbody, but i doesn't drag on the exact area i click on the model, it drags somewhere else on the softbody, these are the screenshots of the softbody setup.

Hi,

The particle dragger drags particles, as the name implies. So it often won't drag from the *exact* point you click, but the particle closest to that point. Normally this isn't very far away from the point you click, unless your blueprint resolution is very low. You can add a ObiParticleRenderer component to your softbody to visually inspect its particles, see if the amount of particles you're using is too low.

kind regards