13-09-2021, 11:03 AM
(This post was last modified: 13-09-2021, 06:00 PM by josemendez.)
Hi!
- What does your blueprint look like? The screenshots only shows the ObiCloth component.
- Is the mesh 2-manifold? Obi does not support non-manifold (malformed) meshes.
Also, is the mesh sufficiently subdivided? it looks extremely low-poly, without enough vertices the simulation will look poor.
kind regards,
- What does your blueprint look like? The screenshots only shows the ObiCloth component.
- Is the mesh 2-manifold? Obi does not support non-manifold (malformed) meshes.
Also, is the mesh sufficiently subdivided? it looks extremely low-poly, without enough vertices the simulation will look poor.
kind regards,