Obi Official Forum

Obi Official Forum > Obi Users Category > Obi Fluid > I put the water in the cup. The fluid motion does not stop.
Full Version: I put the water in the cup. The fluid motion does not stop.
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

psk_1603

03-02-2019, 02:38 AM

So I set the 'sleep threshold' to 1. 
It was like 30 seconds after the video.

What should I do to stop naturally?

josemendez

04-02-2019, 09:33 AM
(03-02-2019, 02:38 AM)psk_1603 Wrote: [ -> ]
So I set the 'sleep threshold' to 1. 
It was like 30 seconds after the video.

What should I do to stop naturally?

Hi,

Try increasing the solver's "damping" parameter a bit, or apply some more friction to the cup's collision material. Having frictionless surfaces and no energy dissipation can lead to endless motion. Also, increasing the amount of density iterations will help reducing the amount of particles that rise to the surface due to pressure building up at the bottom of the cup.
Obi Official Forum > Obi Users Category > Obi Fluid > I put the water in the cup. The fluid motion does not stop.