Obi Official Forum

Obi Official Forum > Obi Users Category > Obi Fluid > 2D Rotate Z-Axis Fluid falls Out
Full Version: 2D Rotate Z-Axis Fluid falls Out
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

p3gamer

25-10-2018, 03:01 PM
I have a cup sprite with an EdgeCollider2d attached. After Obi Fluid particles are in the cup, I then rotate the cup (z-axis) (about 5-10 degrees) and I notice that the particles fall out. Is there a setting that I need to modify to prevent this?

Thank you.
Obi Official Forum > Obi Users Category > Obi Fluid > 2D Rotate Z-Axis Fluid falls Out