05-11-2020, 12:37 PM
(This post was last modified: 05-11-2020, 12:46 PM by canerozdemir.)
Hello,
So I am adding a rope by code and I am able to instantiate it to a degree. However, when the rope is created and after I attach the rope using ObiParticleAttachment it becomes unstable when I move either the end or the start point. It goes back and forth intensely. Attachment works fine, the problem is the intense stretch and I need to make the rope more stable.
Also, how can I set a target on the ObiParticleAttachment with code? I have a start and an end point on the blueprint and I added them by using code. However, I am not able to assign a target to ObiParticleAttachment and it asks for a Obi specific component.
Thank you.
So I am adding a rope by code and I am able to instantiate it to a degree. However, when the rope is created and after I attach the rope using ObiParticleAttachment it becomes unstable when I move either the end or the start point. It goes back and forth intensely. Attachment works fine, the problem is the intense stretch and I need to make the rope more stable.
Also, how can I set a target on the ObiParticleAttachment with code? I have a start and an end point on the blueprint and I added them by using code. However, I am not able to assign a target to ObiParticleAttachment and it asks for a Obi specific component.
Thank you.