05-10-2023, 06:29 AM
(This post was last modified: 05-10-2023, 06:29 AM by josemendez.)
(04-10-2023, 10:20 AM)kebab_traume Wrote: Yeah, stretching definitely was a part of a problem. Now I have this, and here's the partcle render as well. What causes such angle? Does aligned/free parameter (point) affects the angle? In general: what's wrong and how to smooth that angle?
P.S. Really appreciate your help
This is caused by lack of bending resistance. Set your rope's max bending and bend compliance both to zero, then in your ObiSolver set your bending constraint evaluation mode to sequential and increase the amount of bending constraint iterations until you're happy with the results.
Note there's no need to have hight rope resolution if the rope isn't meant to bend much. Reducing rope resolution will improve bending (and stretching) resistance as well as performance, so it's often a good idea.