Copying a rope causes the new rope to "steal" the mesh from the old one
|
Copying a rope causes the new rope to "steal" the mesh from the old one
|
12-02-2018, 04:24 PM
(12-02-2018, 04:01 PM)khalvr Wrote: When copying an ObiRope, it does not seem like you are getting a deep copy of the generated rope mesh. This essentially forces you to re-initialize the old object - which is extremely frustrating since you then need to set up all the constraints once again. Hi Khalvr, Known issue, already fixed in 3.3. Will be out in about a week. cheers, |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Copying a rope causes the new rope to "steal" the mesh from the old one - by khalvr - 12-02-2018, 04:01 PM
RE: Copying a rope causes the new rope to "steal" the mesh from the old one - by josemendez - 12-02-2018, 04:24 PM
RE: Copying a rope causes the new rope to "steal" the mesh from the old one - by khalvr - 13-02-2018, 09:23 AM
|
