05-04-2020, 12:07 PM
(This post was last modified: 05-04-2020, 12:08 PM by DPhI_MUE.
Edit Reason: Typos
)
Hello,
I am a structural engineer. I have some question regarding the capabilities of your solver.
Is it possible to use Virtual Method (Obi Fluid) to simulate the centrifugal casting procedure of concrete? This procedure is used in the production of concrete tubes with the length up to ca. 20 m and diameter up to 2 m. Is this solver comparable to, or even better than the CFD/DEM-solvers available on the market regarding the mentioned simulations? Finally, is it possible to incorporate rheology of Non-Newtonian Fluid fluid to your model (e.g. Bingham, Herschel-Bulkley etc..).
I know this is not a typical question, I would appreciate if you would contact me in PM if this does not belong to the general discussion.
Thanks in advance.
I am a structural engineer. I have some question regarding the capabilities of your solver.
Is it possible to use Virtual Method (Obi Fluid) to simulate the centrifugal casting procedure of concrete? This procedure is used in the production of concrete tubes with the length up to ca. 20 m and diameter up to 2 m. Is this solver comparable to, or even better than the CFD/DEM-solvers available on the market regarding the mentioned simulations? Finally, is it possible to incorporate rheology of Non-Newtonian Fluid fluid to your model (e.g. Bingham, Herschel-Bulkley etc..).
I know this is not a typical question, I would appreciate if you would contact me in PM if this does not belong to the general discussion.
Thanks in advance.