24-01-2021, 12:23 AM
Hi, Obi team!
I was trying to use Obi rope as a string to create a crossbow like object. While prototyping it, I realised that the 'arrow' can easily penetrate the rope model.
By rendering the particles, clearly, the 'arrow' slipped through the gap between particles, as shown below.
![[Image: Screenshot-from-2021-01-23-21-57-28.png]](https://i.ibb.co/160Pt7P/Screenshot-from-2021-01-23-21-57-28.png)
I have reduced the thickness to get smaller particles, however, this did not help much.
How should I change the parameters? Any idea is appreciated!
Many thanks in advance.
I was trying to use Obi rope as a string to create a crossbow like object. While prototyping it, I realised that the 'arrow' can easily penetrate the rope model.
By rendering the particles, clearly, the 'arrow' slipped through the gap between particles, as shown below.
I have reduced the thickness to get smaller particles, however, this did not help much.
How should I change the parameters? Any idea is appreciated!
Many thanks in advance.