07-12-2020, 09:16 AM
(This post was last modified: 07-12-2020, 09:17 AM by josemendez.)
Looks like your mesh is non-manifold (only 2-manifold meshes are supported by Obi), it has scaling issues, or both. I'd lean towards scaling issues.
This is just speculation based on the screenshots you sent, I can't tell for sure without taking a look at the actual mesh. Would it be possible for you to send it to support(at)virtualmethodstudio.com for me to take a look? thanks!
This is just speculation based on the screenshots you sent, I can't tell for sure without taking a look at the actual mesh. Would it be possible for you to send it to support(at)virtualmethodstudio.com for me to take a look? thanks!