13-11-2017, 04:44 AM
Hi,
I was wondering for general advice on how to make the Obi Rope more rigid and less springy? I was able to add more distance constraints (300 or so) and that helped a lot, but I found I also had to take the mass down of each particle (painted to select). I got the rope to be rigid and almost no spring, but my problem is I have a pin constraint on the top particle and a pin constraint on the bottom. The bottom one is attached to a sphere collider and I have to make the sphere rigidbody's weight really light or else the springiness comes into effect in full force again with a heavier weight on it.
Do you think I just have to increase the resolution? I found that resolution (amount of particles) is tough because I'm using a very tiny rope/string.
Any suggestions would be much appreciated, thank you.
I was wondering for general advice on how to make the Obi Rope more rigid and less springy? I was able to add more distance constraints (300 or so) and that helped a lot, but I found I also had to take the mass down of each particle (painted to select). I got the rope to be rigid and almost no spring, but my problem is I have a pin constraint on the top particle and a pin constraint on the bottom. The bottom one is attached to a sphere collider and I have to make the sphere rigidbody's weight really light or else the springiness comes into effect in full force again with a heavier weight on it.
Do you think I just have to increase the resolution? I found that resolution (amount of particles) is tough because I'm using a very tiny rope/string.
Any suggestions would be much appreciated, thank you.