Help Issue with Rope Consistency!

[Kifwat]

I recorded a video to help you:

I start out with a rope with the default resolution (0.5) and default solver/updater/rope parameters. It is quite stretchy and it passes easily trough the collider in the scene. (I add a ObiParticleRenderer component to clearly see what's happening under the hood).

So, I increase the amount of substeps: the rope is much less stretchy and collision detection greatly improves. However, the rope is very stiff (doesn't fold) because the default bending parameters are zero compliance, and 0 bending allowed. So increasing either the bending compliance or the max bending will result in "foldable" rope.

Hope this helps!

Thanks for the explanation, but can you try this and show me how to achieve it?

In your scene, link the the rope's start and end points with two cubes, and then in play mode, move the two cubes (linked with the rope) far from the horizontal object, so the rope is colliding with it. When going as far as you can from the horizontal object, the rope should not pass through it, it should stretch and stay colliding with it.

Check the attached image: 


https://ibb.co/31b9SVj

Or is there any way to increase the amount of particles depending on the rope length? so when it stretch the particles stay close and then it didn't go through object.