Obi Official Forum › Obi Users Category › Obi Fluid v
Help  How to make a self-collecting growing blob?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Help  How to make a self-collecting growing blob?
josemendez Offline
Forum Admin
*******
Posts: 6,321
Threads: 24
Joined: Jun 2017
Reputation: 400
Obi Owner:
  • Rope
  • Cloth
  • Fluid
#4
06-05-2019, 03:12 PM (This post was last modified: 06-05-2019, 03:14 PM by josemendez.)
(06-05-2019, 02:41 PM)MokhovDmitry Wrote: well... I set surface tension coefficient about 2,000,000 but didn't see any difference. Can you share your settings, please?  Gran sonrisa

With such high surface tension, the simulation should blow up straight away (mine does at surface tension = 20). The usual range is 0-10, very rarely going over 3 if you're after realistic results.

Make sure the material you're modifying is the one actually being used by the emitter.
Website Find
Reply


Messages In This Thread
RE: How to make a self-collecting growing blob? - by josemendez - 06-05-2019, 03:12 PM