19-03-2019, 08:06 PM
(This post was last modified: 19-03-2019, 08:07 PM by josemendez.)
(19-03-2019, 09:32 AM)icl92 Wrote: Hi,
I created a new new Obi rod (3DObject->Obi->ObiRod(fully set-up) and copied all the components from the Obi rod Example, the physics did not work.
Hi,
Sorry but we're unable to reproduce this. It works just fine for us. Can you specify exactly what does not work?
Note that the sample scenes often tweak per-particle attributes to get the desired stiffness (particle masses and rotational masses, specifically). Creating a rod from scratch won't yield the same results as the ones in the sample scenes. To increase rod stiffness (resistance to bending), increase your particle's rotational mass.
Same goes for particle phases. Phases dictate which particle-particle and particle-collider contacts are pruned, and which ones progress to actual collisions. Make sure your rope particles are set up in different phases, or they will ignore collisions with each other. See:
http://obi.virtualmethodstudio.com/tutor...sions.html