31-03-2026, 07:19 AM
(This post was last modified: 01-04-2026, 10:02 PM by josemendez.)
Hi,
If I had to take a guess, I’d say your constraints are completely disabled (Stretch/shear and Bend/twist constraints, in the ObiSolver component under the “Constraints settings” foldout) and that you’re moving the entire solver around instead of the rod.
I’d need to take a look at your solver, blueprint and rod setting to properly diagnose this, though.
Kind regards,
If I had to take a guess, I’d say your constraints are completely disabled (Stretch/shear and Bend/twist constraints, in the ObiSolver component under the “Constraints settings” foldout) and that you’re moving the entire solver around instead of the rod.
I’d need to take a look at your solver, blueprint and rod setting to properly diagnose this, though.
Kind regards,