13-08-2025, 04:22 PM
(13-08-2025, 03:35 AM)chenji Wrote: So set it to 0 is wrong in your case. But it also says this so I assume there is a bug as percentage 0 should mean no deformation.
Plastic creep
Once the plastic yield threshold is surpassed, plastic creep determines what percentage of the deformation is permanently absorbed by the constraint.
Yes that is what I mean, if it's 0 then there should be no problem, but the same happens if it's greater than 0.
However I think there might be something else wrong, because I tried to display restDarbouxVectors for each particle and (assuming I did it correctly) I doubt there should be NaN's there.
Is that bug and perhaps related to my problem?