12-08-2025, 03:58 PM
There is rod with some bended initial shape and I push it into place where it's not possible to keep this shape fully. In my case it's some kind of tunnel collider.
The problem is that rod loses it's shape during that operation, like it had plastic deformation enabled. Meanwhile plastic creep and yield is set to 0.
Is that expected outcome?
Example of such a deformation below.
All constraint values are set to default (0).
The problem is that rod loses it's shape during that operation, like it had plastic deformation enabled. Meanwhile plastic creep and yield is set to 0.
Is that expected outcome?
Example of such a deformation below.
All constraint values are set to default (0).