24-06-2025, 11:32 AM
(This post was last modified: 24-06-2025, 11:32 AM by josemendez.)
(24-06-2025, 11:00 AM)chenji Wrote: Hi,
I'm using force zone to simulate bouyancy of fishing ropes underwater. I've set Radial and Accelaration mode. My question is, is it possible to let 1 force zone add different accelaration for 2 different ropes (since different type of fishing rope may has different bouyancy force value)? Note the 2 ropes are bound with stitcher. So they are expected to be underwater at the same time.
Do I have to use 2 force zones and the 2 ropes must in different Obi collider category? Any better ways? Because if there are may ropes it's a bit difficult to keep them in different Obi collider category.
Hi!
It's not possible for a single force zone to apply different acceleration values depending on which actor the particles belong to. How about using force instead of acceleration, and then use the particle's mass to control how much each rope is affected by the force? A heavier rope will sink more than a lighter one.
kind regards,