New component coming to ObiRope 7.0.5: ObiPinhole.
This is something that has been requested quite often: the ability to attach a rope to a point while allowing it to slide/pass trough that point - just like a thread passing trough the eye of a needle.
Pinholes implement that and a lot more: they have full two-way coupling with rigidbodies, they're motorized, and you can even define the friction between the rope and the pinhole. They work for ropes and rods, both open and closed/looped, and fully support rope tearing/cutting. Here's the WIP manual page for them, which contains more details and some use cases:
https://obi.virtualmethodstudio.com/manu...nhole.html
Let me know if you have some feedback, questions or suggestions!
This is something that has been requested quite often: the ability to attach a rope to a point while allowing it to slide/pass trough that point - just like a thread passing trough the eye of a needle.
Pinholes implement that and a lot more: they have full two-way coupling with rigidbodies, they're motorized, and you can even define the friction between the rope and the pinhole. They work for ropes and rods, both open and closed/looped, and fully support rope tearing/cutting. Here's the WIP manual page for them, which contains more details and some use cases:
https://obi.virtualmethodstudio.com/manu...nhole.html
Let me know if you have some feedback, questions or suggestions!