Bug / Crash Issue with Grasping ObiRope Using Two ToolsGood morning, I’m encountering a strange

[josemendez]

the simulation is not able to run anymore without continous lags.

Hi Alice,

If you're using Burst in the editor, make sure the jobs debugger is disabled as that will have a *huge* negative effect on performance.

I created another simulation that would have the same objects and behaviours but when I imported obi and used the same exact codes nothing was working anymore.  
 the behavior of the elastic is totally different even if i keep the same values of the characteristics.

Code can't just stop working due to a crash, it is impossible. More likely your current setup and/or parameters are not entirely identical to the original one.

Now when i grasp it the grasped particle is visually detached from the grasping point and the elastic "updates" when i grasp it, by fastly appearing and disappearing. the code is exactly the same as the one i provided you before.

If the code is the same but behavior is different, that means the parameters used for simulation are not the same. I can't possibly know however, since I don't know how your project was set up before this incident and how it is set up now.

let me know if I can be of any help,

kind regards