12-12-2022, 11:14 AM
Dear Jose,
thank you so much for your input! I found the bending constraint and it behaves like I wanted to. Just one more quick question:
To get a high material strength -> low felxibility I set the bend compliance to 0 and the max bending to 0. To further increase the force that works against the bending I increase the iterations on the bending in the solver. Is that hacky or fine?
Best,
Robert
thank you so much for your input! I found the bending constraint and it behaves like I wanted to. Just one more quick question:
To get a high material strength -> low felxibility I set the bend compliance to 0 and the max bending to 0. To further increase the force that works against the bending I increase the iterations on the bending in the solver. Is that hacky or fine?
Best,
Robert