05-07-2021, 10:26 AM
Hello,
I am using ObiRope as wire that's coming from the battery.
Prior to using, I created a sample obi rope example for wire material with 2 spheres at the end. The behavior of rope was as expected. (Attachment: rope-scale-default.jpg).
Since, the battery wire is of smaller size, I adjusted the scale of the obi rope component inside obi solver in the hierarchy. After this, the obi rope is showing as hanging wire. (Attachment: rope-scale-down-issue-1.jpg, rope-scale-down-issue-2.jpg)
If I change the scale back to 1 in obi rope component, then everything appears to be working fine.
Did anyone faced the same issue earlier? How can I resolve the same? Is there any values in inspector which I can tweak to fix this?
Any help will be appreciated.
Thanks in advance.
I am using ObiRope as wire that's coming from the battery.
Prior to using, I created a sample obi rope example for wire material with 2 spheres at the end. The behavior of rope was as expected. (Attachment: rope-scale-default.jpg).
Since, the battery wire is of smaller size, I adjusted the scale of the obi rope component inside obi solver in the hierarchy. After this, the obi rope is showing as hanging wire. (Attachment: rope-scale-down-issue-1.jpg, rope-scale-down-issue-2.jpg)
If I change the scale back to 1 in obi rope component, then everything appears to be working fine.
Did anyone faced the same issue earlier? How can I resolve the same? Is there any values in inspector which I can tweak to fix this?
Any help will be appreciated.
Thanks in advance.