Obi Official Forum
The particles are too big to fit in. - Printable Version

+- Obi Official Forum (https://obi.virtualmethodstudio.com/forum)
+-- Forum: Obi Users Category (https://obi.virtualmethodstudio.com/forum/forum-1.html)
+--- Forum: Obi Fluid (https://obi.virtualmethodstudio.com/forum/forum-3.html)
+--- Thread: The particles are too big to fit in. (/thread-648.html)



The particles are too big to fit in. - obilww - 14-08-2018

I use Obi Fluid, but my cup is only 5cm in diameter. The particles are too big to fit in. How can I adjust it?


RE: The particles are too big to fit in. - josemendez - 14-08-2018

(14-08-2018, 09:02 AM)obilww Wrote: I use Obi Fluid, but my cup is only 5cm in diameter. The particles are too big to fit in. How can I adjust it?

Increase the fluid material's "resolution" parameter. This will make particles smaller. See:
http://obi.virtualmethodstudio.com/tutorials/emittermaterials.html