+- Obi Official Forum (https://obi.virtualmethodstudio.com/forum)
+-- Forum: Obi Users Category (https://obi.virtualmethodstudio.com/forum/forum-1.html)
+--- Forum: Obi Cloth (https://obi.virtualmethodstudio.com/forum/forum-2.html)
+--- Thread: Particles not coming at corners and edges. (/thread-3603.html)
Particles not coming at corners and edges. - balaji.v - 29-09-2022
Hi,
I am generating obi cloth for small square shape mesh. The particles are not coming at the edges and corners of the mesh.
So I can't able to attach the cloth to another object. Please help to solve this.
RE: Particles not coming at corners and edges. - josemendez - 29-09-2022
(29-09-2022, 09:55 AM)balaji.v Wrote: Hi,
I am generating obi cloth for small square shape mesh. The particles are not coming at the edges and corners of the mesh.
So I can't able to attach the cloth to another object. Please help to solve this.
Hi!
Sorry, I don't understand your question. What do you mean particles are "not coming"? Could you show an screenshot of your cloth blueprint, showing both particles and the mesh?
kind regards,
RE: Particles not coming at corners and edges. - balaji.v - 29-09-2022
Please check attached image
RE: Particles not coming at corners and edges. - josemendez - 29-09-2022
(29-09-2022, 01:39 PM)balaji.v Wrote: Please check attached image
Particles seem to be there, just a lot smaller than the center ones. By default, particles are given a radius based on their connectivity to neighboring particles. Could also be that the normals at these vertices are inverted, and backface culling is hiding those particles, this is hard to tell from your image.
What happens if you give the same radius value to all particles?