+- Obi Official Forum (https://obi.virtualmethodstudio.com/forum)
+-- Forum: Obi Users Category (https://obi.virtualmethodstudio.com/forum/forum-1.html)
+--- Forum: Obi Fluid (https://obi.virtualmethodstudio.com/forum/forum-3.html)
+--- Thread: Help How to set amount of fluid to be emitted? (/thread-3218.html)
How to set amount of fluid to be emitted? - CBGames03 - 06-12-2021
Hi,
Awesome asset, definitely worth the purchase. However I can't for the life of me find out the parameter that sets how much liquid is emitted (right now it's emitting too much)
Any help would be greatly appreciated.
RE: How to set amount of fluid to be emitted? - josemendez - 06-12-2021
(06-12-2021, 01:46 AM)CBGames03 Wrote: Hi,
Awesome asset, definitely worth the purchase. However I can't for the life of me find out the parameter that sets how much liquid is emitted (right now it's emitting too much)
Any help would be greatly appreciated.
Hi there!
Just set the blueprint's capacity. This is the maximum amount of particles that can be emitted by any emitter using the blueprint. See:
http://obi.virtualmethodstudio.com/manual/6.3/emittermaterials.html
Note you can also just set the emitter's speed to zero when you want to stop emitting fluid.