+- Obi Official Forum (https://obi.virtualmethodstudio.com/forum)
+-- Forum: Obi Users Category (https://obi.virtualmethodstudio.com/forum/forum-1.html)
+--- Forum: Obi Rope (https://obi.virtualmethodstudio.com/forum/forum-4.html)
+--- Thread: Help rope setting at the starting point goes (/thread-2749.html)
rope setting at the starting point goes - 0hsyn1 - 12-02-2021
Hi,
first picture, before starting game.
second image after starting unity.
the third picture shows that the rope arrangement is correct.
What could be the rope issue when I start Unity?
I'm sorry for my bad english.
Thank you.
RE: rope setting at the starting point goes - josemendez - 12-02-2021
Hi there,
Without more information I can't help much:
- Are the ropes attached to the sphere? if so, what kind of attachment? static, dynamic?
- Does the sphere have a collider? Does it have a rigidbody?
- What are your solver and rope settings?
RE: rope setting at the starting point goes - 0hsyn1 - 12-02-2021
(12-02-2021, 02:34 PM)josemendez Wrote: Hi there,
Without more information I can't help much:
- Are the ropes attached to the sphere? if so, what kind of attachment? static, dynamic?
- Does the sphere have a collider? Does it have a rigidbody?
- What are your solver and rope settings?
yes, it depends on the capsule. capsule static
yes there is.
I shared the pictures of the settings.
Thank you.
I add 1 more picture here
RE: rope setting at the starting point goes - josemendez - 12-02-2021
(12-02-2021, 02:55 PM)0hsyn1 Wrote: yes, it depends on the capsule. capsule static
yes there is.
I shared the pictures of the settings.
Thank you.
I add 1 more picture here
Make sure the rope isn't attached intersecting the collider if it's set to collide with it, as that will cause an undesired offset in the attachment point and/or unstable simulation. See the last part of:
http://obi.virtualmethodstudio.com/tutorials/pinconstraints.html
RE: rope setting at the starting point goes - 0hsyn1 - 13-02-2021
Hi,
I was using more than one blueprint.
I used the middle working blueprint on other ropes, problem solved.
Thank you.