+- Obi Official Forum (https://obi.virtualmethodstudio.com/forum)
+-- Forum: Obi Users Category (https://obi.virtualmethodstudio.com/forum/forum-1.html)
+--- Forum: Obi Fluid (https://obi.virtualmethodstudio.com/forum/forum-3.html)
+--- Thread: Explosion force on fluids (/thread-2421.html)
Explosion force on fluids - Spectra_7 - 13-08-2020
Sorry for dumb question, but is it possible to add explosion force on fluids?
Setup:
I have a simple spoon animation that comes smashing down on fluids. That's where I want to create an explosion force.
RE: Explosion force on fluids - josemendez - 13-08-2020
(13-08-2020, 02:42 PM)Spectra_7 Wrote: Sorry for dumb question, but is it possible to add explosion force on fluids?
Setup:
I have a simple spoon animation that comes smashing down on fluids. That's where I want to create an explosion force.
You can use the built-in ObiSphericalForceZone to simulate this. Make sure your fluid's atmospheric drag is non-zero, though, or it won't be affected by forces.
If it is not well suited to your use case for whatever reason, you can also write your own custom-calculated forces to the solver.externalForces array.
RE: Explosion force on fluids - Spectra_7 - 13-08-2020
Thanks.
That SphericalForceZone works the way I wanted. But after the force is applied on particles, some particles starts flickering or rotating.