+- Obi Official Forum (https://obi.virtualmethodstudio.com/forum)
+-- Forum: Obi Users Category (https://obi.virtualmethodstudio.com/forum/forum-1.html)
+--- Forum: Obi Fluid (https://obi.virtualmethodstudio.com/forum/forum-3.html)
+--- Thread: Help Can't flow fluid (/thread-1375.html)
Can't flow fluid - mkaanztrk - 19-09-2019
Hello all,
I am new to obi fluid and i am having an issue with the flow.
Whenever i start the simulation, particles stop at the exact point, it feels like an invisible thing forcing against them.
I've tried everything but couldn't find a solution.
Thank you for your help.
RE: Can't flow fluid - josemendez - 09-10-2019
(19-09-2019, 08:34 AM)mkaanztrk Wrote:
Hello all,
I am new to obi fluid and i am having an issue with the flow.
Whenever i start the simulation, particles stop at the exact point, it feels like an invisible thing forcing against them.
I've tried everything but couldn't find a solution.
Thank you for your help.
Make sure your collision material's friction is low enough, and that the solver's sleep threshold is very low too.