Obi Official Forum › Obi Users Category › Obi Rope v
Help  Using existing mesh

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Help  Using existing mesh
skriptsure Offline
General User
Posts: 1
Threads: 1
Joined: Nov 2020
Reputation: 0
#1
08-11-2020, 01:09 AM
Hey guys! Maybe I haven't looked in the right spot, but I can't seem to figure out how to use an existing mesh with this system. Do I have to use the obi rope extruded renderer? I'd like to use an existing mesh if possible. Can someone point me in the right direction? Is there documentation that I've missed?
Find
Reply
josemendez Offline
Forum Admin
*******
Posts: 5,895
Threads: 22
Joined: Jun 2017
Reputation: 364
Obi Owner:
  • Rope
  • Cloth
  • Fluid
#2
09-11-2020, 10:33 AM (This post was last modified: 09-11-2020, 10:33 AM by josemendez.)
(08-11-2020, 01:09 AM)skriptsure Wrote: Hey guys! Maybe I haven't looked in the right spot, but I can't seem to figure out how to use an existing mesh with this system. Do I have to use the obi rope extruded renderer? I'd like to use an existing mesh if possible. Can someone point me in the right direction? Is there documentation that I've missed?

Hi,

The extruded renderer takes a flat 2D section and extrudes it along the rope path. To use a custom mesh, you should use ObiRopeMeshRenderer. See:
http://obi.virtualmethodstudio.com/tutor...modes.html
Website Find
Reply