Help Fishing Pole/Line

[Natty]

Hi Natty,

Not too sure how I can go about helping you with this one.

Rope initial shape/length is defined by a path. This path passes trough all control points in a sequential fashion (pass trough first control point, then second, etc). Each control point has a couple of "tangent handles" sprouting from it, that determine the orientation and curvature of the path as it passes trough the point. This is the typical spline you'd find in most other 2D/3D programs.

This video might be of help, if you haven't watched it yet:
http://obi.virtualmethodstudio.com/videos.html

All good for now.  I'm going to move into my actual project and try setting it up there so I can get a better feel of how casting would work.  I set up a brief test in my empty scene of casting out but noticed that the bobber is being pulled by the rope still when it lands in the water.  I'll probably have to tweak my buoyancy code and/or turn off the mass of the rope so that it does pull the bobber as much.

Are there any files that I can exclude from the package and/or add to .gitignore?  I will only be using Oni (no Burst), thank you!