Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Help  Save/Load Obi Rope state and rope network state synchronization
#10
(27-05-2021, 08:28 AM)pmike Wrote: Hello! 
One more question. How can I pause the rope after loading the state, i.e. turn it into a "static spline" for a while?
Depending on what you want to do, you can disable the ObiRope component or the ObiSolver component.

Disabling the rope will remove all particle/constraint data from the solver, but keep the rope mesh being rendered. Disabling the solver will keep all particle/constraint data in place, but will stop updating the simulation.
Reply


Messages In This Thread
RE: Save/Load Obi Rope state and rope network state synchronization - by josemendez - 27-05-2021, 08:44 AM