Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Help  Space in obi rope with pins
#2
(16-03-2019, 07:16 AM)SamViolin Wrote: Hello, I try to make wires with connectors on both ends for VR. The user will be able to take connectors in his hands. At first, I wanted to implement using startPrefab and endPrefab, but they are impossible to interact with and move. Then I tried to implement a longer wire using "pin constraint" based on the example in the "Rocker" scene. But during кщзу initialization, there is a space between "obi rope" and GameObjects. 

I tried to fix this problem by changing the "pin constraint" position, but it did not help. Is there any way to fix this problem?


[Image: image.png]

[Image: image.png]

[Image: image.png]


[Image: image.png]
Thank You

Sam Violin.

Hi,

The particle at the end of the rope is colliding with the sphere (add a ObiParticleRenderer component to your rope to clearly see the issue). Simply disable collisions between them by setting the particle phase to the same value as the sphere collider. See:
http://obi.virtualmethodstudio.com/tutor...sions.html
Reply


Messages In This Thread
Space in obi rope with pins - by SamViolin - 16-03-2019, 07:16 AM
RE: Space in obi rope with pins - by josemendez - 16-03-2019, 02:14 PM