17-05-2018, 10:36 PM
I have a problem where the rope hanging from the end of my crane swings like a penduluum, but I want it to have some stiffness so as you rotate the crane it doesnt sway so much. The rope starts at the tip of the crane arm.
I'd like to put two verts close together right at the top of my rope, so I can enforce a low-bending cable running off the end of a crane (see picture).
Alternatively, having the ability to pin 'angle' and not just 'position' would work too.
Anyways to accomplish this?
Thank you!
I'd like to put two verts close together right at the top of my rope, so I can enforce a low-bending cable running off the end of a crane (see picture).
Alternatively, having the ability to pin 'angle' and not just 'position' would work too.
Anyways to accomplish this?
Thank you!