Pin constraint offset

[josemendez]

Using Obi Rope 3.3, I setup pin contraints on a couple of particles and attached them all to a ObiCollider. The thing is, I select the particle and a add the pin constraint. It looks correct when its done. It works the way as stated in the tutorial.

But as I play in the editor, the offsets changes, like the picture below



Any clue what is going on? There is a script associated with the rope that deals with restoring the rope state when some key is pressed only.

Judging from the image, I cannot tell if the pin offset (cyan dot) has moved or (much more probable) the particle is lagging behind due to insufficient pin constraint iterations, or wrong constraint order (in 3.3).

Have you tried stepping frame by frame, to see if the offset actually moves?