|
Rope 'jumps' when a particle is added or removed
|
05-03-2018, 12:57 PM
(05-03-2018, 11:58 AM)Wilbert Wrote: Turning off 'Bending' in the solver made the problem largely disappear while maintaining a good enough simulation of the cables. Good that this worked for you! If you still notice any jumps, try reducing the mass ratio between the ropes and the crane load. That should minimize the problems caused by mass lumping. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Rope 'jumps' when a particle is added or removed - by Wilbert - 05-03-2018, 10:28 AM
RE: Rope 'jumps' when a particle is added or removed - by josemendez - 05-03-2018, 11:07 AM
RE: Rope 'jumps' when a particle is added or removed - by Wilbert - 05-03-2018, 11:58 AM
RE: Rope 'jumps' when a particle is added or removed - by josemendez - 05-03-2018, 12:57 PM
|
