Hello, for the past week I've been trying to render a fluid in a beaker using the voxel mesh component though the fluid ends up forming a ball from this picture below.
[Image 1] : https://ibb.co/rZzjT3p
I also had some problems setting the fluid to stop it from emitting every time (When emitting it falls down rather than staying inside the beaker). Just wanted it stable inside the beaker to make it realistic in such a way when I want to pick up the beaker the fluid is able to move or have physics like in real life when you pick up a glass of water.
I am not sure if this was the right way but I set the damping to 1 and the fluid did not fall though I don't know if this will affect the fluid later on when trying to mix with another beaker.
Hopefully, I get some feedback/help.
[Image 1] : https://ibb.co/rZzjT3p
I also had some problems setting the fluid to stop it from emitting every time (When emitting it falls down rather than staying inside the beaker). Just wanted it stable inside the beaker to make it realistic in such a way when I want to pick up the beaker the fluid is able to move or have physics like in real life when you pick up a glass of water.
I am not sure if this was the right way but I set the damping to 1 and the fluid did not fall though I don't know if this will affect the fluid later on when trying to mix with another beaker.
Hopefully, I get some feedback/help.
S.T