21-01-2021, 02:03 PM
(21-01-2021, 01:27 PM)sadiq Wrote: I'm using Obi fluid for mobile devices and optimization is a major step for them. I need to destroy or disable the particles so that only visible particles are loaded and there aren't any performance issues.
You can disable the solver's "simulate when invisible" checkbox. See:
http://obi.virtualmethodstudio.com/tutor...olver.html
Note that you can only enable/disable entire solvers, disabling individual particles doesn't make any sense as the behavior of the fluid would change completely (losing/gaining volume, sudden pressure spikes, etc).