08-01-2021, 10:10 PM
(This post was last modified: 08-01-2021, 10:22 PM by taylorjames9.)
Are there any instructions or tips for setting up Obi Fluid so that it will show in Oculus Quest? We have been able to successfully verify that Obi Cloth and Obi Softbody work in Quest, but we have not been able to verify that Obi Fluid is visible in headset. We have downloaded and installed the Burst package and jobs system. I have put the Obi Fluid Renderer script on all cameras rendering VR. I see a tip in Frequently asked Questions that says that we need a "different camera for each eye", but I'm not sure how that's different from the two cameras that are set up in the OVR (Oculus) camera rig prefab.
Are there any tips or instructions for getting this to work on Quest 1 or Quest 2? Any success stories? We have also set the Project Settings->Oculus -> Stereo Rendering Mode to Multipass. We certainly look forward to using this package. Thank you in advance for any help and advice.
Best,
-James
Are there any tips or instructions for getting this to work on Quest 1 or Quest 2? Any success stories? We have also set the Project Settings->Oculus -> Stereo Rendering Mode to Multipass. We certainly look forward to using this package. Thank you in advance for any help and advice.
Best,
-James