Rope Is Hanging From The Control Point

[canerozdemir]

Could it be that the rope is attached inside a collider? In that case, just disable collisions between the rope ends and that collider, by setting them to the same phase.

This issue is explained in the manual, along with the solution. See the last bit of:
http://obi.virtualmethodstudio.com/tutor...aints.html

let me know if this helps!

Hi there Jose,


I tried setting both control points, nails and the circle phases to 1. Nails and circle phases on the obi colliders are 1 and the control points have phase 1. However, same behaviour continues. Control points masses are 100, in case it might help, but the mass doesn't seem to affect it either.