Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Rope distance from attached object
#1
Hi,

I love your rope asset so far! I was wondering, is there a way to get the rope snug up against the collider? I followed along with your youtube tutorial to make a rope attached to a cube, but using all defaults, my cube is a considerable distance away from the rope at runtime. When I add the Pin Constraint (pinned to object) on the bottom rope particle, it automatically adds an offset in the Y access. I noticed, if I drop that Y access down a bit, it brings it closer to the collider. In the tutorial, it also mentioned adjusting the distance in the solver itself, I did that as well, but no impact for some reason. Any ideas what I'm doing wrong?

Here's a screenshot:
[Image: LQqp9Hj.png]

Youtube tutorial I followed

I can also provide you the scene if needed, let me know. If I revert to defaults, it is the same result I have found.

I should note: I pinned the top particle to the top cube instead of pinning in place, which is what was done in the tutorial.
Reply


Messages In This Thread
Rope distance from attached object - by dignifiedweb - 26-09-2017, 04:48 AM