06-05-2021, 04:53 AM
(This post was last modified: 06-05-2021, 04:55 AM by Hakazaba.
Edit Reason: clarifications
)
Ok, i made a test scene with a single rod being animated and it works fine, but in the scene where i have 8 rods being animated at the same time, the changes show no effect on rest position (simulation otherwise runs without issue using the origional blueprint rest position)
Could 8 of these scripts running at the same time (and using the same solver) somehow conflict?
Would it be worth me writing a new script to change the darboux vectors of all 8 at the same time?
(in full, the scene has 8 rods being animated and having their rest positions modified, 8 rods that are not being modified, 2 volume baloon obi cloth with obi proxy meshes. I also tried recreating the solver incase that was configured incorrectly with no change)
Could 8 of these scripts running at the same time (and using the same solver) somehow conflict?
Would it be worth me writing a new script to change the darboux vectors of all 8 at the same time?
(in full, the scene has 8 rods being animated and having their rest positions modified, 8 rods that are not being modified, 2 volume baloon obi cloth with obi proxy meshes. I also tried recreating the solver incase that was configured incorrectly with no change)